Page 1 of 1

My R6 build up

Posted: Fri May 10, 2024 9:42 pm
by ohioyj
So many years ago at this point, I was shopping for a used motorcycle and came across a deal on a new R6. It had a used bike price because it was two years old at that point and had never sold. I didn't have any good pictures of it with the huge rear fender, so this image is the closest thing to stock I could find:

Image

One of the first things I did was peel off all the decals:

Image

After having a couple people attempt to switch lanes into me, I decided full exhaust was necessary.

Image

Image

This was also a good time to throw a K&N air filter, and do smog block off plates:

Image

Re: My R6 build up

Posted: Fri May 10, 2024 9:42 pm
by ohioyj
While hunting for exhaust, I really only liked the looks of the GYTR slip on, so that's what I went with:

Image

The next modification was new sprockets. I decided to go -1 / +2

Image

Decided to upgrade the front pads, and lines as well:

Image

While the bike ran ok with just a PowerCommander with the exhaust, it wasn't perfect. I decided to add an AutoTune module to the system. Unfortunately this meant tearing the bike apart again. Once I added the speed sensor wire to the PCV so I could create different maps for each gear the AutoTune was just what the bike needed. It's been a great addition:

Image

To run at the local track I needed a tethered kill switch, and PMR had the nicest one I could find:

Image

Re: My R6 build up

Posted: Fri May 10, 2024 9:43 pm
by ohioyj
To eliminate the factory mirrors, I made up some brackets to mount mirrors behind the fairings.

Image

Image

After seeing the condition of the bolts and bearings in the swing arm of my DRZ I decided it was time to do a service on the R6 swing arm. I'm glad I did, as pretty much all the bolts needed polishing to get rid of the corrosion, but it was a ton of work. The project started by removing the radiator if that explains how much of the bike had to come apart.

Image

After not being able to find any alternative to the expensive OEM tool for the swing arm nut, I decided to make one. I had to sacrifice a $9 socket, but it was far cheaper than the Yamaha tool:

Image

It was also time to replace my sprockets / chain again. This time I opted for a SuperSprox:

Image

Re: My R6 build up

Posted: Thu Aug 22, 2024 5:11 pm
by B.C.1deep.
Damn. That os gonna be sick.